Thursday, November 12, 2009

Welcome Sacramento Area Machine Knitters

Just a reminder...

This blog entry is here to assist the Sacramento Area Machine Knitter's Guild in advertising their meetings on the Internet. I hope you will stop by one of our meetings and share your latest project with us!

Meet with local Machine Knitters. Chat and discuss the art of machine knitting. All machines brands users are welcome, from the Brother, Bond to the Electronic Passap.

Sacramento Machine Knitters Guild, meets on the 2nd & 4th Thursdays 10am-noon (we meet throughout the summer at our normal days and times if there is enough interest).

We meet at St. Andrews United Methodist Church, 6201 Spruce Avenue, Sacramento, CA (off I-80 at Greenback exit, turn right at first street, up about 2 blocks, bear right at the curve and the church is straight ahead).

Updated: 05/17  Contact info has changed as Marilynn (pronounced Mary Lynn) has moved to Colorado.  We wish her all the best.  For more information about the Guild and upcoming training topics call Hugh Hall at 916-332-5190.

November 12th - Today's meeting was informative as always. I learn something new every time I go. Hugh came in with a great idea about making swatches for all the punch cards for his knitting machines. He then attaches the number of the card to the swatch. It reminds him when he's looking for a pattern what it looks like and which number card it is. I'm going to get started on this for my machines. Looking at the cards I can never guess what the card is going to look like.

Tuesday, November 3, 2009

Figure of 8 cast off

I had a hard time finding this. So, I wanted to put it here to find when I'm ready to try it.


Figure of 8 cast off


This transfer tool cast off on the single bed produces a stretchy cast off which is good for necks or anywhere requiring a bit of stretch.

The cast off is started at the carriage end of the knitting, at main tension, (no loose row) at either end of the machine though you may find it easier from one end than from the other. Remove the yarn from the feeder and pull some yarn through the tension mast to slacken the tension. Position about the first 10 needles in upper working position (UWP).

*Knit the first stitch by hand.

Pull the first needle with its stitch back to non-working position. The stitch will enlarge. If you are right handed put your left thumb nail on this stitch below the gatepeg and push this needle to holding position (HP) with your right hand. The large loop is on the shaft of the needle and cannot shrink as you are holding it. Hold the transfer tool so the end with one prong is facing you and lying above the machine bed and the needle in holding position with the tip just behind the large loop. Pick up the loop from behind and place it on the second needle by bringing the end of the tool towards you and down and dropping the stitch onto the needle from above. You have made the figure of 8 and can see it around the two needles. Gently pull the yarn so that the figure of 8 is firm around the needles.

Knit the second needle by hand and repeat from * as for the first needle to the end. When you get to the end of the row break off the yarn and pull the end through the last stitch. As you use up the needles in UWP bring more out. The yarn needs to be slack so pull more through as needed. You can drop the cast off stitches off some of the needles in holding position if you wish as it can make casting off the rest of the row easier - but always leave a few in HP Remove the knitting from the machine by gently pulling it towards you. If you have to stop mid row either return the needles in UWP to WP or hang the 3 pronged transfer tool onto the needles nearest to the casting off to stop them falling off. Be careful of the needles in HP.
Frances Murray